First of all, it is very necessary to choose a good mold company. Many companies can make chair molds. However, there are not many such companies to do a good set of chair molds. The following will give you an analysis of the basic quality points of chair molds.
The quality requirement, first of all, is the life of the mold. A good mold can produce thousands of molds, and some have dozens of molds that need to be repaired. The life of the mold should be determined according to its own production capacity. Check the hardness of the steel. The hardness of the chair mold should be at least HRC33. In order to control the cost, generally about 500,000 molds should be made of P20 material. In a good point the cost of materials is much higher.
Some customers need to make many kinds of chair molds, and the same style does not need flower plates. Some customers will say that it is not necessary to open a lot of molds. I can answer you now, of course not. In this case, you only need to open a pair of molds. The flower board can be made of multiple inserts. It depends on your company's needs. The finished inserts can be used interchangeably.
Chair mould, for Jingzan Mould Company, is a very mature craft. Whether it is a back chair or a single ordinary stool, hundreds of styles have been made. Walking into the sample room of Jingzan molds, you can see that all kinds of chairs are all shipped molds.